Addams Family, The
Bally, 1992You're currently viewing posts by Pinsider codered9394.
Click here to go back to viewing the entire thread.
Look through the manual and find the connector at the board these are controlled off of. Make aure your connector is plugged correctly. Also make sure you dont have a bad connection where the wire goes into the connector. Check ribbons cables to make sure they didnt loosen up during travel. This should get you started.
You're currently viewing posts by Pinsider codered9394.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/advice-for-fixing-a-beheaded-addams-family?tu=codered9394 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Augusta, GA
Auckland, NZ