Quoted from copyboy311:Have the adjustment failure message on startup of Rollergames and went through most of the troubleshooting suggested in this thread, but not any ram/rom testing. I have a remote battery holder, so that's the first thing I did; replace the batteries.
Found no bad or missing contacts or connections in the battery holder. Go through reset and free play setting procedures with door audit/adjustment switches and game will play fine until I turn it off. When powering on again, I get the error messages. If coin door is closed, error is "adjustment failure." If door is open when powering on, it's "factory settings." Still have to go into menus and set to free play to get game play again.
Not sure where to go next. Could the door open-closed switch have anything to do with it?
Game not holding memory after battery holder replacement/voltage checks
Suspect D2 broken or faulty
sys11 2 (resized).pngsys 11 img (resized).pngSys 11 (resized).png