Quoted from steve1515:I don't know what I'm talking about
Just kidding, but I was thinking that the cap on the flipper board may also need replacing. You should give this a try and let us know the results.
You're currently viewing posts by Pinsider grumpy.
Click here to go back to viewing the entire thread.
Quoted from steve1515:I don't know what I'm talking about
Just kidding, but I was thinking that the cap on the flipper board may also need replacing. You should give this a try and let us know the results.
Yea I miss spoke on that, but was meaning that C1, C3 need to also be replaced when you change C5 and C6. Should be very interesting results. Maybe a small improvement in flipper power?
Quoted from DumbAss:will regular incandescent bulbs still work? I'm thinking they should with the modification in place.
Yes they will.
The only thing I would change is the zero ohm resistors. Just put in a cut off lead from one of the larger diodes. Nice work!!!
Quoted from Beebl:I'm still scratching my head over where this resistor is kbliznick is talking about in the schematic..
On the inner connect board the manual shows R-1 as a resistor or a jumper. In your machine it will be a jumper, remove it and install the resistor in its place. Then you can run #89 bulbs or 12 volt Leds.
sof2 (resized).PNGQuoted from Templewd:For f14 system 11a games do I just need to cut the warming resistor off of the flash boards?
Yes if your in a hurry, or you could unsolder them and save them for later if you want to put it back.
You're currently viewing posts by Pinsider grumpy.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/adding-led-flashers-to-system-11-games?tu=grumpy and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.