Working on an Addams family that has the dreaded 5v reset issue. Removed driver board card to do some testing, reseat connectors, inspect for cracked solder, etc. Removed board, took a whole bunch of measurements, then replaced board back in the pinball. Now when the flashers fire (even in attract mode), the flippers slightly flip). It is not a full flip, but the flipper gets about halfway up, then releases again.
Now, I could have messed up putting the connectors back onto the board, but most of them are pokey-oked so you can't make a mistake. The first game did blow the solenoid fuse, but I stacked that up to a 20 year old fuse and reseating the connectors gave the flippers/magnets a little more juice. (Magnets were going when it blew). I replaced the fuse with proper replacement, and that hasn't failed again. Any suggestions would be appreciated and thanks for the help.
-H