I put out an email to Spooky today, but want to see if any of you can also direct. I was getting a loud "ping" noise anytime I hit the right flippers, so I went about replacing the 2 coil stops for the 2 right flippers. When switched out, I didn't notice any movement to the coil stops I was replacing so I probably still have the problem. BUT I can't determine that because the machine went bananas when I started a new game. I found the following yellow wire came loose from a terminal. Can anyone trace back to where it belongs on their machine? This is near the upper playfield drop target.

IMG_1143 (resized).JPG

IMG_1144 (resized).JPG

IMG_1145 (resized).JPG

Yeah I believe it is the terminal towards the bottom of the picture (one below where the 2 black wires meet), but honestly it was such a small dab of solder I'm not entirely certain. Hard to tell. Very minimal solder there if anything.

Spooky just confirmed it:

"It goes to the switch that has just the black wire on it.

it goes to right of the black wires.

Christopher"