I have one of the new hard drives with the new software from dutch pinball. They had to send me one when my old one couldn't access the OS behind the scenes.

If I knew what the hell you just said. I'm right over the IL boarder. If you are close, you could stop over and show me hows it's done.

but then, why would his rug skill shot work fine. It's a much longer plunge to the left orbit, than to the upper playfield.

if the PS has a switch for 240v and 120V. make sure it's in the correct position. I had a game that i had for years, never reset. Then brought it to the new house and would get random resets. Found out, the PS was switched to 240, so all those years, it was running at half voltage and still working. But the wiring in the new house, would have more draw, and would dip just a hair too low and cause resets and lockups. So check that out and make sure.

make sure there isn't a wire pinched and cut, shorting against a metal bracket. I had a TZ crash this way, where someone screwed down the mini playfield with the wires pinched in the U bracket in the back. Everything was all polywampus

the software freeze up today. Was doing female form mode. Finished it in the pops. Hit the rug to finish it out. Game was stuck on the points for the mode and froze up.

i had to power off as well.