OP

Quoted from cosmokramer:

Test fitting with some mis matched parts, I want to do all my fine tuning before I tear it back down for the artwork...

Speaker panel and translite fit well, time to move on to back box latch and hinges...
Went to the Museum of Pinball today to help prepare for arcade expo for a short while, while I was there I took the opportunityto make a template for the large plastic I am missing. I am going to try to make a new one, however it really looks like it is going to be a pain in the ass. I traced the profile onto some paper, marking the areas where I will have to heat and bend...

Drilling holes for lightboard hardware...

A few minor adjustments and the light board is good to go...

Lock and trim pieces fitted...lock is temporarily screwed in, t nuts will be installed before final glueing of parts. These last few details are quickly being crossed off the to do list...