I had a problem with my jerk settings in the slicer that needed to be turned down when I was getting layer shift like that
(Topic ID: 246329)
Linked Games
High Speed
Williams, 1986
Topic Gallery
You're currently viewing posts by Pinsider zzap.
Click here to go back to viewing the entire thread.
3 months later
2 months later
I'm sure if you post up the dimensions, and a rough sketch of what you're thinking (maybe a photo of the area too), someone could model something simple up
1 week later
Quoted from joetechbob:Any good recommendations for Fusion 360 tutorials? I can do a lot of damage with Tinkercad, but it does feel a bit limiting -- albeit easy to pick up.
This guy has a lot of good content - got me up and running
2 months later
Quoted from MeesterPieter:I wanted some other leds for my inserts on my homebrew project so i ordered some cheap chinese WS2812 boards and made a bracket to fit them easily under the playfield.
when i'm done tinkering i'll share them on my thingiverse [quoted image][quoted image][quoted image][quoted image][quoted image]
Good design with that little lip and the two posts to hold the pcb! Can't quite tell from the photo, did you add hot glue, or just melt the posts down to secure?
4 months later
Here's a few of the parameters of eSun PLA+ to give you an idea of how the properties of 3d filament can be measured.
Density(g/cm3) 1.23
Heat Distortion Temp(℃,0.45MPa) 53
Melt Flow Index(g/10min) 5（190℃/2.16kg）
Tensile Strength(MPa) 63
Elongation at Break(%) 20
Flexural Strength(MPa) 74
Flexural Modulus(MPa) 1973
IZOD Impact Strength(kJ/㎡) 9
10 months later
Promoted items from Pinside Marketplace and Pinside Shops!
Orange, CA
You're currently viewing posts by Pinsider zzap.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
