Carlyle, IL
Quoted from DDDwingmaster:I have the feeling that riveting puts a lot of pressure on the plastic that could result into cracking after a while. Maybe adding a washer on the back could spread the load better.
Would screwing in the contacts not been easier?
If it's printed correctly it should hold up just fine.
There are a lot of options when you slice a part to print on how it prints the part. The amount of perimeters, the infill %, the infill pattern, the overlap on your perimeters, etc. You also have a choice of what material you use for the print some are stronger than others and more resistant to heat, chemicals, more or less flexible, etc.
