Plugs are on 3 side
Game does not end after 3 balls. I tried going thru the schematic but I'm messing up somewhere
Any other ideas how to fix?
(Topic ID: 300006)
Colleyville, TX
Quoted from dsquared_314:pinhead52
3 ball. End game relay pulls in after 5 ball
5 ball. End game relay never pulls in.
Rivets on player disk have been cleaned
there is a "last ball" relay that should pull in at the "start" of the last ball. Is this happening? this is what the rivets drive.
Note in the chain above there is a contact on U, 1st ball relay.
Ending after the 5th ball suggests the 3-5 jumper is not in, dirty jones plug? jumper across this...
Quoted from dsquared_314:pinhead52
3 ball play. Ball 4 light comes on when 1st ball is in play. Why would player unit stop at ball 4 river on first ball?
Sounds like the wiper is miss-alingned/rotated by 120 degrees? There is one location on the player unit that both stack 1 is raised ans stack 5 is raised, this is the position for ball1 p1.
Quoted from dsquared_314:pinhead52
3 ball. Last ball pulls in on 5th ball and 3rd ball light comes on
Should 1st ball relay pulls in when ball goes thru the trough switch or when hits a target. It pulls in after a target or any roll over switch is hit
1st ball relay pulls in with scoring
Promoted items from Pinside Marketplace and Pinside Shops!
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
