Working on my 2nd EM Pin (my 1st Project machine pick up from a private sale).
I had everything working expect I had a flickering "V" light. I pulled the play field out to work on the "V" Trip relay.
I notice one of the female connector was raised a little. Pushed it down and it broke off. (Swear, curse, curse).

I know bally jones plugs are touchy.

Has anyone repaired/replaced on of these. If replacing, where can I find a part. Pictures would be nice. Part numbers and a store would be better.

Grr. another one broke when I removed the plug to take a picture.

Good news is the "V" doesn't flicker anymore.

Jones plug (resized).jpg

Thanks. I was hoping for a "macGyver" repair.
If I should replace it, should I go with a William plug instead. (I heard they were made better).

Since is was replace vs repair. I took a shot and soldered the broken tabs back on.
1. A thin bead of solder on edge where it broke
2. press the tab back on while heating the top of the tab with the soldering iron. (Held tab with needle nose pliers).

They appear to be holding OK and no loose connections.

If they break again I will replace them.