Columbus, IN
Yeah they look upside down - and you need a 7 position housing 
(Topic ID: 87502)
You're currently viewing posts by Pinsider johnwartjr.
Click here to go back to viewing the entire thread.
If only half of them are on, that typically means the relay isn't working. Usual cause is cold solder joints on that relay board. Reflow them and try again.
2 weeks later
Finding contacts for pins is pretty straightforward, I've never found it challenging.
Order them from GPE or Big Daddy
https://greatplainselectronics.com/
http://bigdaddy-enterprises.com/
Both these vendors will help answer your questions if you have any, and typically the prices do beat Mouser, Jameco, Digikey, etc.
Ratcheting crimpers are very valuable in pinball repair. I prefer the original Molex / Sargent crimpers, but they are not inexpensive. HTR-2445A for .156, HTR-2262A for .100, HTR-1719C for .062 and HTR-1031E for .093.
Promoted items from Pinside Marketplace and Pinside Shops!
You're currently viewing posts by Pinsider johnwartjr.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
