Westwood, NJ
Looking for a .156 20 pin IDC connector. Anyone have this in stock or at least 2 I can purchase? Thanks.
(Topic ID: 313701)
You're currently viewing posts by Pinsider barakawins.
Click here to go back to viewing the entire thread.
Joe, were they the 20 pin IDC pin molex connectors? The ones where you have punch the wire into? can't find them on there.
Hi Slochar, I'm looking for the 20 pin IDC molex connectors where the wires splice into the connector. Not sure where to find that one.
Thanks for that information.
PinballManiac40 I'm working on a special project requiring splitting a 20 position molex signal amongst two of such connections.
Thanks Ed. I’m working on a bally kiss. There is a 20 position molex on the aux lamp driver board that drives the kiss lamps on the backglass. I need to use the 20pin idc’s to make a splitter harness for J2 so I can power some leds in a separate kiss topper I had made. Hopefully this will work well.
You're currently viewing posts by Pinsider barakawins.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
