Hello everyone. My parents have a Munsters B&W Premium and this plastic apparently came off and was in the Dragula lane. Does anyone have an idea about where this piece would have come off from? Thanks for you help!

IMG_0933 (resized).JPG

IMG_0934 (resized).JPG

IMG_0935 (resized).JPG

IMG_0936 (resized).JPG

That's it! Thanks hd60609 and mbwalker for your help! I will reach out to Stern regarding the piece.

What is the best way to get access to Grandpa's Laboratory? I need to clean that playfield and install the ramp cover. Thanks everyone!

Thank you!

Yes. There should be two screws holding down the opto and you will unscrew them and there is a molex connector under the table that you will detach. Screw in the new one and run the cable down and connect the molex. I replaced one for my parents last weekend. You can reach out to stern and open a support ticket and they might send you one. Or you can but one from Pinball Life for $10.00: https://www.pinballlife.com/stern-long-range-opto-receiver-assembly.html

I never had to replace or adjust the rail. Perhaps someone who has the table handy can answer that for you Tugboat1. I will check this weekend and see if I can get the answer for you if no one has answered before then.