What are owners doing to remove the dust from underneath of the lower/mini playfield? remove the lower playfield or remove the clear section of the main playfield?
cheers

Great, thanks Mark, i was actually going to ask you today about this today during our PM"s.
cheers
Trevor

Great info, thanks very much.

So I received my topper last week, I removed it from the box today to install and there was a loose screw in the plastic bag that wraps around the topper,
So I pulled the topper apart and found where the screw came from, there was also another screw that was nearly all the way out, so I checked all the other screws and nuts and about 80% of them were loose or could have been tightened up a bit more, so i would recommend to everyone that has this topper to check all the screws and nuts in there topper,
In the photo below were the red arrow is the nylon piece slides up and down on the metal base every time the raven pops in and out, I am thinking about putting a bit of super lube on here to make it easier for it to slide so there is no friction.

Also, whilst I have the topper apart I am going to replace the raven white light to possible a red light, do you thing red would suit?

I also just want to confirm that the clock only has one hand?

Cheers
Trevor

69A1D08A-A113-410C-8BC4-8648A0D0E487 (resized).jpeg

F7B295C9-90AD-4D66-BD86-18A91361E1E7 (resized).jpeg

Thanks for the reply’s everyone, good point, I didn’t think about the coil dust, so I’ll just leave that alone and just change the raven light to either red or purple.
Have a happy new year everyone,
Cheers
Trevor

Does anyone have a link or know where to purchase the 5v bulb for the topper? I have decided to install a purple bulb for the raven but our supplier in Australia doesn't carry this bulb.
cheers
Trevor

Is there any update or does anyone know if stern rectified the issue with the wire form near Herman from bending?
cheers