Anyone know where I can buy one of these? It goes in the C12 position on the WPC-95 Driver board. PBL, Marco, GPA, BAA or bigdaddys doesn't seem to sell it or even a bigger one.
(Topic ID: 38575)
Sheridan, WY
One great big "HUH?!?!"
The WPC-95 doesn't use a 10000uF, 63V cap for C12 on the driver board.
Are you replacing a cap that somebody already replaced...and they went a bit high in voltage?
C12 is supposed to be a radial 10000uF, *35V* cap.
Don't go with a snap led cap as a replacement - you run the risk of damaging the board's plated through hole. Use something more along the line of a Nichicon UVR1V103MRD. But be aware these are about 0.4" taller than the existing cap. Make sure you have the head room above this cap.
Ed
Sana'a
This is what is in the machine now in both the C10 and C12 spots so they must have been replaced at some point. The cap in C12 broke off and was sitting in the bottom of the backbox.
This is my first WPC-95 so I am not sure what "Right" looks like yet.
Thanks for the heads up.
Promoted items from Pinside Marketplace and Pinside Shops!
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
