Hey everyone. Looking for some help here. My trolls seem to more often not work than work. When I power the machine up and go test, I can hear the 'buzz' of them trying to engage, but they don't raise. When I go inside the cab and jostle them around a bit then go back to test they will then raise and lower. Thoughts? It is almost like they may not be getting enough power? Was also thinking an alignment issue, but given both are not functioning right, I doubt that. Thanks for any insight.

Thank you so much. Just looking at the whole mechanism more closely made me realize it was an alignment issue because of loose/missing screws causing the coil to be not properly aligned. Tightened it all up and added a couple of missing screws and all appears well in the troll world.

Thank you for directing me towards the obvious. One of these days I'll get it all figured out.